BERNINA embroidery software ARTDesign V1 - EConPC Rel3.1

New EConPC Rel 3.1 for all users of BERNINA embroidery software ARTDesign V1 with an aurora sewing-/embroidery system.


Brief Description

After BERNINA Embroidery Software ARTDesign V1 was installed for the Windows Vista™ or Windows® 7 operating system, it was not always possible to start up the EconPC application without an error message. On the attempt to send embroidery data from the BERNINA Embroidery Software ARTDesign V1 to a connected aurora sewing machine, various error messages which prevented the start-up of the EconPC application would occasionally be displayed. After further attempts, it was possible to transfer the embroidery data to the EconPC application. With the EConPC Rel 3.1 update, this problem has been eliminated.

Note: Every computer may be assembled and configured differently, which may mean differences from the messages and figures shown here. The different configurations may affect the behaviour of the BERNINA Embroidery Software V5 or the EConPC program.

Requirements

 To allow you to install EconPC Version 3.1, it is essential that the following requirements be met:

  1. One of the following operating systems is installed on your computer:
    Windows® XP SP2 / Windows Vista™ / Windows® 7
  2. An operating BERNINA embroidery software ARTDesign V1.0G (incl. Service Pack1 for BERNINA ARTDesign V1) installed on your Computer.
  3. Your embroidery computer is one of the aurora models.
  4. Administrator rights for your computer.

If the following BERNINA Embroidery Software ARTDesign version is installed on your computer, we recommend the prior installation of Service Pack 1 for BERNINA ARTDesign V1:

  • BERNINA embroidery software ARTDesign V1.0D

Note:

The information as to which BERNINA Embroidery Software ARTDesign V1 version is installed on your computer can be gleaned from  'Help – About…'  from the main menu bar of your installed BERNINA Embroidery Software.

Service Pack 1 for BERNINA Embroidery Software ARTDesign V1...

  • ...is available for Importers and Dealers on the Infogate (Ref. No.: 13391). 
  • ...can be downloaded free of charge by end customers fromwww.bernina.com/downloads
    (one-off registration necessary).

File-informations

File nameFile sizeContent
EConPC_Rel31_ARTDesign.zip approx. 8 MBEConPC V3.1 with ADX V7.14:
incl. Hotfix for EConPC V2
Installation instructions EConPC Rel.310.44 MBInstallation instruction

Important information:

To make possible the installation of the EconPC Rel 3.1 update on your Windows® XP SP2 / Windows Vista™ or Windows® 7 Computer, it is essential that the BERNINA Embroidery Software ARTDesign V1.0G is installed.
 
For EConPC Rel3.1 ".NET Framework 1.1" need no longer be uninstalled:  EConPC Rel 3.1 uses .NET Framework 2.0, which is installed along with the BERNINA Embroidery Software ARTDesign V1.

Download Section:

Installation manual EConPC Rel31 (444kB)
EConPC Rel31 ARTDesign (7997kB)

Recommended:

We recommend that you install EConPC Rel 3.1 on each computer on which the BERNINA Embroidery Software ARTDesign V1 is installed and on which the aurora sewing-/embroidery system is used to embroider.

« back